Project topic: By measuring the voltages falling on each component of the circuit board on the circuit board shown in the diagram above, it will be tested whether it is between the given limit values.

Measuring way; LabVIEW software language will be used and necessary measurements will be made with the help of 1 analog input card and 2 relay cards. 

Used Materials,
DAQ card (VTK 1050 - Analog Input Card)
DAQ board (VTK RELAY 4 High speed relay board)
2 x 220 ohm resistors, 4 x LED
Supply
Cables for necessary connections

Gains;
Analogue signal reading, data acquisition,
Relay board usage,
Analog card and relay card synchronous use,
Project management,
Subvi creation / use within the project,
Reinforcement of the frame / sequencing structure,
Limit control,
Reinforcing the table structure,
Screenshots of the Project Software will be as follows;

Main Program Screenshot

Block Diagram screenshot 1- Measurement Preparation

Screenshot of Block Diagram 2- Measurement and Results

Block Diagram screenshot 3- Reporting 

Screenshot of component.vi (subvi) in Block Diagram

Screenshot of mux.vi (subvi) in Block Diagram

Details of materials used,
1 Piece VTK 1050 Analog Input Card ('Ludre Yazılım' Domestic Production Data Acquisition Card), click here for product features.

2 pieces of VTK Relay 4 high speed relay card ('Ludre Yazılım' Domestic Production data acquisition card) click here for product features.

Power Supply
Battery is used as power source in this application.